2007-2010 Kia Rio Rostra Cruise Control Installation Instructions
The instruction provide in this manual will guide you to install the cruise control from Rostra for KIA Rio. The cruise control can be applied to 2007, 2008, 2009 and 2010 KIA Rio. Inside the manual you can follow complete guide with picture figures to make ease you during maintenance also include the wiring diagram and electrical test for troubleshooting.
2007-2009 Jeep Wrangler Rostra Cruise Control Installation Instructions
All information you need to install Cruise Control from Rostra to 2007 2009 Jeep Wrangler provided in this manual installation guide. Every step of procedure also represented by an image to get more clearly on the instruction.
Check voltages on the pink wire in the ecm at position 26 for 5 volts. The violet wire at position 27 should read 5 volts. the yellow wire at position 13 should have a ground no higher than 3 ohms of resistance.
Infiniti G35 KPTech Remote Sunroof Control Module Installation Instructions
This manual provide complete step by step manual (DIY) to install Remote Sunroof Control Module from Kpierson Technologies. This product can be applied/install on your Infiniti G35, you need experience to install this product properly.
Connect this wire to the Body Control Module (BCM) RAP output that connects to the OEM sunroof controller. This wire can be found in the main BCM wiring harness above where the harness splits to go in to the drivers side door and will read 12VDC when either the ignition or RAP system is on. With the ignition off and the drivers door open the wire Should Measure 0vdc.
Hyundai Tiburon TWM Shifter Cable Bushing Kit Installation Instructions
All procedures in this manual could be use for Hyundai Triburon 2003+. This manual contain step by step install procedure for Shifter Cable Bushing Kit from TWM Performance.
Working in the engine bay, use a Phillips head screwdriver to remove the 2 screws over the driver’s side headlight and a 10mm socket with a ratchet and an extension to remove the 10mm bolt holding the splash guard. Remove the splash guard from the engine bay.
Hummer H2 Epik Visors Installation Instructions
This document contain installation manual for Visors VL8000 Series from Epik. Disconnect the vehicle’s negative battery terminal. (Black wire) Please see Visor Removal Instructions to remove the passenger side visor.
Remove the ‘A’ pillar trim and kick panel on the passenger side and route the Video Cable and Ground Wire around the front edge of the headliner and across to the ‘A’. Install the visor monitor and mounting brackets to the headliner by reversing the Visor Removal Instructions.
